深圳市锐步科技有限公司

1, have helipads place will install helipads series lamps and lanterns, so helipads can be put into use.
2, helipad series lamps and lanterns is according to the location of the installation and use of the function is different, can be divided into light, approach the lamp, border light, aimed at lamps and floodlights lamps and lanterns, and each helicopter landing must be equipped with a barometer.
. Light: at night, because of the influence of the environment to the airport to pick out the light can play a remote visual guide, mark the location of the heliport.
That xenon tube light, hair white light;Light intensity is: 2500 CD, power: 15 w.
Settings: light should be set on the helicopter field or nearby, had better be in an elevated position, and make the pilot in the close range of the airport does not feel dazzling, if necessary can be closed when close.
Installation method: for the surface installation, only the light of the power cord is connected to the control cabinet or a separate switch, can get a job.
2). The approach lights: at night to give the pilot shows that the airport main approach direction.
Light source: persistence and flash light.Constant light type: Led light source, white light, the light intensity is 350 CD, power of 25 w.Flash: xenon gas torch source, hair white light, the light intensity is 3500 CD, power of 15 w.
Settings: approaching lights in every two intervals between standard is 30 meters, but in some elevated the apron when used, due to the influence of the installation position can reduce the spacing, but shall not be less than one meter, if less than a meter approach the effect of light, no direction indicator of the approach.
Installation: for the surface installation, according to the design position needs can be installed directly on the surface of the fixed at the airport.Approaching lights in all of the power cord connected in parallel and then connected to the control cabinet or a separate switch power supply, can work, if the flash type lamps and lanterns of lamps and lanterns must also pay attention to the lights and the flash sequence, on the basis of constant light type flash will increase a synchronous signal type lamps and lanterns, please take a closer look at the instructions before installation.    
(3). The boundary lamp: labelled helicopter grounding and the boundary of the region from the ground.
Light source: LED light source, the constant light yellow (beginning in 2009 for the green constant light), light intensity is 25 CD, power of 10 w, chassis with easy folding parts (when the plane bumps lamp, lamp can fall in a timely manner, will not affect the safety of the aircraft).
Installation method: a. the surface installation, according to the designed position needs can be installed directly on the surface of the fixed at the airport, all the boundary of the power cord connected in parallel and then connected to the control cabinet or a separate switch power supply, can get a job;B. embedded installation: my company provides the size of the embedded boundary light figure, according to our customers to provide the size of the figure, the reserve is like our lamps and lanterns is about 2 cm in diam. The installation of the groove, and the line will be well kept, in order to prevent the power cord of lamps and lanterns and embedded wire connector into the water leakage, need to install the waterproof connector.When a customer to install lamps and lanterns in tank after installation, connect the power cord, reoccupy expansive cement on gap to fill the empty fixed.