Shenzhen Ruibu Tech Co., Ltd

Proposed for the use of the night the runway or quasi for daytime and nighttime use precision approach runway, all must be set the runway lights.Suggestion: fitting for the runway visual range less than 800 m or so in the daytime under the condition of minimum standard of running off the runway, should set the runway lights.location
The runway edge lights must be along the runwaylength with the runway centerline equidistant set on two parallel lines.
Runway edge lights must be published as a runwayused along the edge of the area or along the distance from the edge of asetting is not more than 3 m.
Suggestion: as the width of the runway area inpublished more than 60 m, in determining the distance between the two lines ofthe runway edge lights should be considered when running properties, the runwaylights light distribution characteristics of lamps and lanterns and othervisual AIDS to navigation in the service of the runway.
Runway edge lights must attend to evenly spacingarrangement, such as instrument, runway lights shall not be greater than 60 mspacing, such as the meter runway, distance between lamp shall not be greaterthan 100 MB.The track on both sidesof the axis of the corresponding lamp must be located in perpendicular to theaxis line.Crossing the track, ifthe driver can still provide enough guidance, side lights available irregularspacing or cancel some lamps and lanterns.
features
The runway edge lights must be constant variablewhite hair light, except the following:
A) the runway entrance of cases, the startingpoint from the runway to move between the runway entrance light within mustshow red in the approach direction;
B) from takeoff runway began to see, at the endof the runway at the end of the 600 m or a third of the runway length (both inits small value) that a light yellow display.
Runway edge lights must be in to take off orlanding from either direction of the pilot light on to provide all thenecessary direction of the guide.Whenthe runway edge circling lamp to provide boot, lamps and lanterns must be onall the azimuth.
Sideof runway lights on all of the azimuth required from the level above to 15 °Angle must be within the range of the light, the light must be strong enough toadapt to a fitting for take off or landing runway visibility and the needs ofthe ambient light conditions.In any case, the light intensity should be atleast 50 CD, only in the absence of light around the airport, the lightintensity can be reduced to not less than 25 CD, in order to avoid make thedriver feel dazzling.